Cylinder tip
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=210163
Printed Date: 22 Feb 2026 at 8:05pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Cylinder tip
Posted By: SteveM C/IL
Subject: Cylinder tip
Date Posted: 22 Feb 2026 at 1:18pm
 This may help anyone who's trying to get a cylinder apart for resealing. They are all over Gleaners and some Allis tractors. Instructions are to go through oil port with screw driver and pry snap ring over to deep groove. I struggled by trying to wedge screw driver in groove near end and twist it to move ring. Could not do it. Finally I just pryed against the ring and it moved over easily starting at the end. It is rather simple when done right but was kicking my butt for quite awhile. I think it will be just as easy going back together if I reverse procedure. Thing is,I've done this before and don't remember have such a time....but it's been a few yrs. Been a couple weeks since I did the picture thing and was kinda edgy. Got my notes out,they aren't that great. Thanks 7060. |
Replies:
Posted By: 8070nc
Date Posted: 22 Feb 2026 at 3:28pm
|
Ive done several. Not intuitive in the beginning but once i fugured it out it works pretty good ------------- 1984 80780 1957 D14 DES 300 with 25000 engine 616 tractor |
Posted By: SteveM C/IL
Date Posted: 22 Feb 2026 at 6:01pm
| Assembly didn't go well. Took 8lb sledge to "tap" it through the seal and then I managed to push the snap ring over the groove into the cylinder. Had to tie both ends to the cherry picker to pull ram past the seal,of course destroying the lip. Call this a "do over". |