Print Page | Close Window

8010 remote hydraulic couplers

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=208967
Printed Date: 19 Nov 2025 at 12:41am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: 8010 remote hydraulic couplers
Posted By: automaticdave
Subject: 8010 remote hydraulic couplers
Date Posted: 18 Nov 2025 at 4:58pm
l have quite a time not destroying the O-rings in the remote couplers, in a seal kit that l got from AGCO (#70264224) there is 2 rubber o-rings & 2 white scarf cut plastic rings. l figured the white scarf cut rings would be a backing ring & would act as a guide for the pioneer hose fitting to enter the coupler and protect rubber rings, but there's not enuff room for both rings. Can someone tell me what I,m missing here ? Thanks Dave



Replies:
Posted By: Mike Kroupa
Date Posted: 18 Nov 2025 at 8:17pm
Just went through this also on one of our 7060's with the Bruining ,(AC), hydraulic couplers. It was a pita getting both the o-ring and back up ring seated properly. The backup ring is needed and I trimmed a little off each end to get it placed. The back up ring goes on the inside of the o-ring. It appears to me that these are a little different from the originals, once installed no leaks. Good Luck , Mike



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net