TUBE ASSEMBLY 229367 D19
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=203297
Printed Date: 23 Nov 2024 at 12:59am Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: TUBE ASSEMBLY 229367 D19
Posted By: WD45
Subject: TUBE ASSEMBLY 229367 D19
Date Posted: 20 Sep 2024 at 10:43am
Wanted one Tube assembly 229367 for D19 item 1 on page 195 of D19 March 1964 dealers parts book. This is one of the lines for power steering.
------------- Fred Dunlop, G,B,CA, WC,WF, 3 WD45`s,gas, diesel and LP,U,D10 series III, D12,D14,D15 SERIES II,D17 Series IV in Gas and Diesel ,D19 GAS and D21,170 185,210 ,220 an I-600 8070 fwd, 716H and 1920H
|
Replies:
Posted By: tbran
Date Posted: 20 Sep 2024 at 12:25pm
Checked all my sources, NLA - no NOS... D15D D17 D19 all use this , sorry.. looks like inverted male flare - either make one or salvage yards.
------------- When told "it's not the money,it's the principle", remember, it's always the money..
|
Posted By: ryan(IN)
Date Posted: 20 Sep 2024 at 12:56pm
If there’s enough straight section of tube on both ends you could get compression fittings that then crimp to hydraulic hose to get it made.
------------- ryan 1984 8070 FWA,1979 7060,1975 7040,1971 190,1960 D-17D,1957 D-14, 196? D-19G, 1975 5040,1971? 160,1994 R62
|
Posted By: WD45
Date Posted: 20 Sep 2024 at 4:25pm
I had to cut the tube above the 90 degree bend to put a socket on to get the fitting out. Tube was leaking at other end. Had a hose made up but the fitting was too long causing the hose to rub the steering and radius rods.
------------- Fred Dunlop, G,B,CA, WC,WF, 3 WD45`s,gas, diesel and LP,U,D10 series III, D12,D14,D15 SERIES II,D17 Series IV in Gas and Diesel ,D19 GAS and D21,170 185,210 ,220 an I-600 8070 fwd, 716H and 1920H
|
|