8030 steering (again)
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=202782
Printed Date: 23 Nov 2024 at 11:07am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 8030 steering (again)
Posted By: aunt allis
Subject: 8030 steering (again)
Date Posted: 19 Aug 2024 at 5:13pm
|
I'm back working on the 8030 Allis and after rebuilding steering cylinder and making sure hydraulic oil level is correct at the sight glass, I still can not get it to steer to the right. It will steer ok to the left and if I raise front end up and manual turn tires to the right...as I drive it eventually works its way into a left turn and I can not correct it. I can spin the steering wheel fast and effortlessly to the right with little or no resistance.
|
Replies:
Posted By: DrAllis
Date Posted: 19 Aug 2024 at 8:30pm
|
8000 series had a small problem wearing out the splines that connect the steering wheel shaft to the orbitrol input socket. I would think it would bother both right and left, but maybe not ?? Assuming the steering wheel shaft splines are not the issue, disconnect both hoses at the steering cylinder and plug/cap the ends of the hoses so no oil can pass. Start the engine, throttle it up and try and turn the steering wheel. It shouldn't turn either way, or not very much either way. If the steering wheel turns, you have an orbitrol problem. If it basically doesn't turn, the steering cylinder has a problem.
|
Posted By: aunt allis
Date Posted: 19 Aug 2024 at 8:58pm
Posted By: DrAllis
Date Posted: 21 Aug 2024 at 5:39pm
|
Waiting for the results..............
|
|