Allis Chalmers C Thread size adaptors
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=202253
Printed Date: 23 Nov 2024 at 6:59pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Allis Chalmers C Thread size adaptors
Posted By: John426
Subject: Allis Chalmers C Thread size adaptors
Date Posted: 14 Jul 2024 at 8:26am
|
Hi I am looking for the thread size for adaptor on the Allis C hydraulic. Pump out , Ram in , Pipe , Control valve left right   |
Replies:
Posted By: steve(ill)
Date Posted: 14 Jul 2024 at 9:46am
|
Ii think most of the hydraulic fittins are a 1/4 inch PIPE thread.. Noramlly the hose is 1/4 inch male pipe and the fitting in the valve / cylinder has a 1/4 inch swivel pipe fitting.
the second photo you posted says HOSE, but looks like a TUBE ??? The Allis C only used 1/4 inch PIPE and hose fittings.
------------- Like them all, but love the "B"s. |
Posted By: steve(ill)
Date Posted: 14 Jul 2024 at 9:49am
most systems i have seen use this fitting that screwes into the valve/ cylinder, and has a swivel to screw to the hose... all 1/4 inch pipe. ------------- Like them all, but love the "B"s. |
Posted By: PaulB
Date Posted: 14 Jul 2024 at 9:54am
|
Here on this side of the water, 1/4" NPT (National Pipe Taper) Is easy to find. In France you may have to go to some industrial Hydraulic place to get what you need to do what you want. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: CA13414
Date Posted: 14 Jul 2024 at 6:41pm
Thanks! Forgot that I need two of these!!! ------------- Helping the aged survive and thrive! 1953 CA |
steve(ill) wrote: