Pistons
Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Pulling Forum
Forum Description: Forum dedicated to Tractor and Garden Pulling
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=201021
Printed Date: 23 Nov 2024 at 3:09am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Pistons
Posted By: Ol case mike
Subject: Pistons
Date Posted: 23 Apr 2024 at 1:21pm
|
Is there enough room to install wd 4-1/8 power crater pistons onto a gleaner z these are not wd45 power crater pistons I know sp46 need to be machined some to clear I was just wondering about the power craters
|
Replies:
Posted By: DrAllis
Date Posted: 23 Apr 2024 at 2:06pm
|
M & W piston kit SP-46 fits the 4 inch stroke WC/WD engines and have a Power Crater type bowl in them. If you install them in a WD45 or D-17 engine with the 4 1/2" stroke you need to machine .170" off the top so they don't smack the cylinder head. As far as what you're wanting to use, I have no idea what the compression distance/height is. Might work. Might not.
|
Posted By: Ol case mike
Date Posted: 23 Apr 2024 at 3:41pm
I have both sets MW 4-1/8
And the smooth bowl I thought them was called power crater that is also 4-1/8 set I was thinking about putting the smooth bowl into a gleaner z code I don’t know either pin height both are still in motors with wd cranks I was just wondering if the smooth bore needed any machine work to be installed like the sp46 piston needs it’s for a unstyled wc pulling tractor that has a stock z gleaner
|
Posted By: DrAllis
Date Posted: 24 Apr 2024 at 12:15pm
|
In the "KNOWLEDGE" section of this website, down near the bottom of page 1, you will find "Compression ratio calculator for 226 engines".....good info for you.
|
Posted By: HudCo
Date Posted: 24 Apr 2024 at 10:24pm
|
got ross duplicating some sp46 pistons (should be done any day now )for me as we speak thanks to steve fischer getting me a piston they are going in my d17 series 4 engine
|
Posted By: HudCo
Date Posted: 24 Apr 2024 at 10:26pm
|
they will be a two ring piston and lighten alittle bit
|
Posted By: DrAllis
Date Posted: 25 Apr 2024 at 6:33am
Posted By: HudCo
Date Posted: 25 Apr 2024 at 8:39am
|
no i decided to leave them the same pin to top hieght, and mill them at the machine shop
|
|