CA Oil Filter Bracket Torque Specs
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=199090
Printed Date: 14 Nov 2024 at 9:10am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: CA Oil Filter Bracket Torque Specs
Posted By: dfwallis
Subject: CA Oil Filter Bracket Torque Specs
Date Posted: 07 Jan 2024 at 11:28am
| I coulnt find a spec for the bracket to block bolts (3 different manuals). I used 15ft-lbs, but that seems to have squished the cork gasket so much it cut and squished it out of alignment (new gasket ordered). I'll have to check the bracket for warping before I reinstall it (was not warped before, doesn't visually look warped now). Recommendation? |
Replies:
Posted By: steve(ill)
Date Posted: 07 Jan 2024 at 12:18pm
|
I have never measure the "torque", but i would guess your 15 # was high.. Looking at the gasket as you tighten will tell you when to stop... I have used the cork before and i have also cut out fiber gasket to use... normally wipe a thin layer of RTV to seal it to the block. .... the cork probably gets less torque and more compression as compared to a fiber gasket.
you would be further ahead with a "torque" value of something like " snug to contact, then 1/2 turn of the wrench"...... if the gasket starts to squirt out the side or compress more than about 30% of its thickness, your going to far.
------------- Like them all, but love the "B"s. |
Posted By: jaybmiller
Date Posted: 07 Jan 2024 at 1:14pm
|
little 's' snug NOT capital 'T' tight.... ------------- 3 D-14s,A-C forklift, B-112 Kubota BX23S lil' TOOT( The Other Orange Tractor) Never burn your bridges, unless you can walk on water |
Posted By: SteveM C/IL
Date Posted: 07 Jan 2024 at 1:52pm
|
That's not a real torque #...it's more of a "feel" and observe....I agree with small s snug. Tight enough it doesn't loosen and still seals. It has no pressure so a sealer is helpful.
15# don't sound like much but feels LARGE when tightening small soft things.
|
Posted By: Steve in NJ
Date Posted: 07 Jan 2024 at 2:31pm
|
I've had better luck with just the ole "snug". I do what Steve suggested. I use a super thin layer (applied with my finger) of high heat Orange RTV on the block side, and just snug down the bolts till the gasket starts to move. Done! Steve@B&B ------------- 39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife |
Posted By: dfwallis
Date Posted: 07 Jan 2024 at 4:22pm
I did use RTV. It's probably sealed, but since the gasket is cut strangely, I'm going to redo it anyway.
|
Steve in NJ wrote:Posted By: DiyDave
Date Posted: 07 Jan 2024 at 5:09pm
1/4 of an ugga dugga, at most! ------------- Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need! |