21" tool box
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=198069
Printed Date: 24 Sep 2024 at 11:18pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 21" tool box
Posted By: HudCo
Subject: 21" tool box
Date Posted: 04 Nov 2023 at 10:53pm
|
when did they start putting the 21 inch long tool box othe d 17 tractor the series 4 parts tractor that i got has that. it will hold somthing
|
Replies:
Posted By: DrAllis
Date Posted: 04 Nov 2023 at 11:02pm
|
My series 3 had the long tool box, only on the right side instead of the left. It will hold the official wheel tread wrenches it is that long.
|
Posted By: HudCo
Date Posted: 05 Nov 2023 at 7:27pm
|
my series 1 is going to get that long tool box
|
Posted By: AC720Man
Date Posted: 06 Nov 2023 at 5:16pm
My series 1 had one when I purchased it, bottom was pretty rusted out so I replaced it with a new one. Not sure if the long box came from the factory on a series 1 but it fit perfect. And yes, it holds a lot of tools.
-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
|
Posted By: IBWD MIke
Date Posted: 07 Nov 2023 at 8:00am
All right, anyone ever put one of these on a WD or 45? Probably be kind of in the way I would guess. Bigger toolbox would be nice on these old girls.
|
Posted By: DrAllis
Date Posted: 07 Nov 2023 at 8:05am
|
If you located the rear edge of the box in the same place and extended the extra length forward, you'd be alright. I think the lift arm latch comes kinda close when the arms are fully up as it is.
|
Posted By: IBWD MIke
Date Posted: 07 Nov 2023 at 8:16am
I could check out the lift-arm/latch thing here in just a bit. I only have the one 21" box and it's rusted on the 17b pretty good. Maybe remove it and hold it up for comparison. If I wind up keeping this series 3, which is a pretty good possibility, it will need a new box.
|
Posted By: IBWD MIke
Date Posted: 08 Nov 2023 at 9:05am
Yesterday I checked this out. Raised the plow fully up, measured the three inches on each end, plenty of room. Now I just need to procure a new box or two!
|
Posted By: HudCo
Date Posted: 09 Nov 2023 at 11:04pm
|
it would be nice looking mounted on the frame rail of a wd
|
|