Wheel weight bolts
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=197310
Printed Date: 25 Sep 2024 at 5:19am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Wheel weight bolts
Posted By: sparky
Subject: Wheel weight bolts
Date Posted: 21 Sep 2023 at 7:37pm
My 185 has 18.4 X 30’s and I have a set of one piece Taylor weights to put on it. Will the bull gear housings keep me from installing the weight bolts or do I have to pull the wheel center off? TIA.
-------------
It's the color tractor my grandpa had!
|
Replies:
Posted By: jiminnd
Date Posted: 21 Sep 2023 at 8:34pm
Not sure what taylor weights are but I think you can get bolts in if wheel is in right spot. Also the width of wheel setting just to reach in there.
-------------
1945 C, 1949 WF and WD, 1981 185, 1982 8030, unknown D14(nonrunner)
|
Posted By: AC720Man
Date Posted: 21 Sep 2023 at 9:23pm
Spin out rims? If so spin them out and then you should definitely be able to get them on.
-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
|
Posted By: sparky
Date Posted: 22 Sep 2023 at 1:33pm
Yes it has spin outs. I’ll check it out more closely. I’ll probably yank the bull gear pans and change the gear oil. That should give me more clearance. Thanks.
-------------
It's the color tractor my grandpa had!
|
Posted By: AC720Man
Date Posted: 22 Sep 2023 at 1:54pm
Even spun all the way out I had to remove the tires/wheels on my D 17 to change the oil and replace the gasket.
-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
|
Posted By: sparky
Date Posted: 22 Sep 2023 at 2:01pm
Well if push comes to shove I’ll block her up and buzz the tire/wheel/center off and lay it down and mount up the weight and then yank the pans off. Sounds like a winter job in the shop is on the agenda. Thanks
-------------
It's the color tractor my grandpa had!
|
|