Farm Equipment - 190XT Power Director

Print Page | Close Window

190XT Power Director

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=191302
Printed Date: 11 Aug 2025 at 8:13pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 190XT Power Director

Posted By: meells
Subject: 190XT Power Director
Date Posted: 16 Oct 2022 at 5:00pm

I rebult the power director on my 190xt over the winter. Everything was done according to the book. I read on here to use the 7000 plates for clutch pack, so I did that as well. I put everything back together and only had low range. Even when put in high and neutral I only seemed to be in low. Can I get some pointers on what I may have done wrong?
Thanks.

Replies:

Posted By: DanWi
Date Posted: 16 Oct 2022 at 5:19pm

Simple thing but what I did wrong the first time was not line up power director housing for oil to pass thru to high side.

Posted By: meells
Date Posted: 16 Oct 2022 at 5:24pm

I appreciate the response. It's been long enough I'll need refamiliarize myself with some of the steps. I believe mine is lined up properly.

Posted By: DrAllis
Date Posted: 16 Oct 2022 at 5:33pm

The passageway is for low side. Always air test a Power Director clutch before rolling tractor back together.

Posted By: DanWi
Date Posted: 16 Oct 2022 at 6:29pm

Thanks doc couldn't remember was a long time ago when I did mine. Just knew one side didn't work because of that mistake.

Posted By: Clay
Date Posted: 17 Oct 2022 at 8:49am

How much air pressure is required for the air pressure test?

Posted By: DrAllis
Date Posted: 17 Oct 2022 at 8:55am

Shop air pressure is best, but 50 lbs should be enough to KNOW the both clutches can and will apply.

Posted By: Clay
Date Posted: 17 Oct 2022 at 8:52pm

Thanks Dr. I will write that information down in my power director notes.