Farm Equipment - D-10 sleeve standout

Print Page | Close Window

D-10 sleeve standout

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=189632
Printed Date: 20 Aug 2025 at 6:51am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D-10 sleeve standout

Posted By: tractorboy
Subject: D-10 sleeve standout
Date Posted: 21 Jul 2022 at 3:29pm

Checked sleeve standout on son's d 10 [reliance kit], two are dead flat even, 2 are maybe .001. Book calls for .002-.005 . Even though the book says "DO NOT USE BLOCK SEALER' I kinda want to put a tiny line around the flange. Do any of y'all pros do this ??? thanks keith so. va.

Replies:

Posted By: DrAllis
Date Posted: 21 Jul 2022 at 6:48pm

Hopefully you installed the sleeves without the O-rings to measure stand-out. I think I'd remove all of them and measure the thickness of the flanges to see if the workmanship is the problem. They should all be the same.

Posted By: Alex09(WI)
Date Posted: 21 Jul 2022 at 6:53pm

Can't speak to the D10 engines, but my experience with WD-D17-170 engine sleeves is they are made wrong. The aftermarket sleeve flanges are made too thick giving too much standout. So it is possible that the sleeves are made wrong.

-------------
www.awtractor.com
A&W TRACTOR 920-598-1287
KEEPING ALLIS-CHALMERS IN THE FIELDS THROUGH THE 21ST CENTURY