How much to remove off hollow shafts
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=189449
Printed Date: 29 Nov 2024 at 7:21am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: How much to remove off hollow shafts
Posted By: KansRustbuzzard
Subject: How much to remove off hollow shafts
Date Posted: 12 Jul 2022 at 4:23pm
When polishing out the galling, how much can I remove without getting in trouble? The inside shaft polished off real clean while chucked in the lathe but the short shaft is a lot worse right under the gear as in picture. Am I going to mess up  by taking too much out of the inside? Thanks
|
Replies:
Posted By: DrAllis
Date Posted: 12 Jul 2022 at 7:40pm
| They run pretty close together. That is why they occasionally seize when bearings get worn a bit. I have opened them up as much as .010" (removing .005" x two) without any regrets. Too loose and they can't ever do what they did. |
Posted By: KansRustbuzzard
Date Posted: 13 Jul 2022 at 11:39am
| Thank you for that information, I am going to take some more off, no reason to do this twice! |