Construction and other equipment

Print Page | Close Window

HD4

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=184130
Printed Date: 30 Nov 2024 at 10:42pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: HD4

Posted By: Mike K
Subject: HD4
Date Posted: 23 Oct 2021 at 6:51pm

Just purchased a HD4 with final drive inoperative on right side when sitting The cover on the bottom for the final drive is pushed away from the casting. Like the bolts are stretched

Any ideas before I remove the cover

Replies:

Posted By: pinball
Date Posted: 23 Oct 2021 at 11:16pm

if your lucky and it was hit you might be able to replace it. if it was due to bull drive gear then your probably in for a big job and expensive. worse scenario is the bearing went out and it let your bull gear start wobbling which possible could mean you have to find a good case. look at the rear drive sprocket and on each side you will see a flat bracket and see if the rear drive sprocket is touching a bracket. there should be couple inches clearance on both sides. you also can take the plug out of the lower part of the case and see if theres is any metal in there.

Posted By: Coke-in-MN
Date Posted: 24 Oct 2021 at 3:41pm

if the drive or driven gear are bad - good luck in finding them -
Lower outer bearing went out in my machine and I had the case machined to accept new bearing cup , with all the work it was $400 a side to do them + cost of new bearings , seals and axle added after .

-------------
Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something.
"Challenges are what make life interesting; overcoming them is what makes life meaningful."