D19 yr 1963
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=153739
Printed Date: 24 Nov 2024 at 12:26am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D19 yr 1963
Posted By: T-bone_indy
Subject: D19 yr 1963
Date Posted: 06 Sep 2018 at 5:19pm
|
I just purchased a few days ago.Getting the rim repaired now. so far I have change the oil and filter hydraulic filter added 4 gallons of hyd fluid greased every fitting i can find Repair hydraulic leaks and fuel leaks Loader is functioning now I have a question when raising the bush hog the arms go down immediately once i release the leaver. is the loader a 500? where can I order pins for it? I would appreciate any points and suggestions on the operation of this tract and thanks in advance also the owner stated it only has hi gear not sure if there's adjustment that can be done to correct that. The previous owner has manuals for the tractor hes trying to locate them. |
Replies:
Posted By: T-bone_indy
Date Posted: 06 Sep 2018 at 5:24pm
|
Posted By: T-bone_indy
Date Posted: 06 Sep 2018 at 5:26pm
|
Posted By: DSeries4
Date Posted: 06 Sep 2018 at 8:01pm
|
That is not a 500 loader. ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: Pete from IL
Date Posted: 06 Sep 2018 at 8:02pm
| It looks like a Freeman loader to me. You may have to repair the pins you have or make some new ones. Someone on here may know if new pins are available somewhere. |
Posted By: hillmonkey
Date Posted: 06 Sep 2018 at 8:15pm
|
I like it, good save. |
Posted By: 1852 Moore Farm
Date Posted: 06 Sep 2018 at 9:15pm
| Nice project. |
Posted By: Travis(NE)
Date Posted: 07 Sep 2018 at 12:14am
| There is a check valve inside the valve for the traction booster that will leak internally which causes the lift arms to not stay up. Usually it can be taken apart, cleaned, and work again when reassembled. |