D10 manifold
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=148546
Printed Date: 14 Sep 2025 at 3:38am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D10 manifold
Posted By: Ranse
Subject: D10 manifold
Date Posted: 16 Mar 2018 at 9:16pm
|
I need to drill and tap the holes that holds the muffler on. I think it's probably pointless to try to get the broken bolts out. How deep are the holes, or do they go all the way through? I think they would easier to tap if I drilled them all the way through, although this is probably not correct. I'll be putting bolts back in them so there shouldn't be a leaking problem. I can probably do this with the manifold on the tractor, but I think I'm going to remove it. It has a new gasket, I just wondered if I could re-use it? Thanks Ranse. |
Replies:
Posted By: DiyDave
Date Posted: 17 Mar 2018 at 5:48am
Exhaust gasket is probably toast, anyway, they get brittle after just a few hours of running. I'd just get a sharp bit, and drill it still on the motor...
|
Posted By: GregLawlerMinn
Date Posted: 17 Mar 2018 at 8:52am
|
All that I have seen went into the manifold bore and were tapped. ------------- What this country needs is more unemployed politicians-and lawyers. Currently have: 1 D14 and a D15S2. With new owners: 2Bs,9CAs,1WD,2 D12s,5D14s,3D15S2s, 2D17SIVs,D17D,1D19D;1 Unstyled WC |