Pulling Forum - ARP head studs for 45

Print Page | Close Window

ARP head studs for 45

Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Pulling Forum
Forum Description: Forum dedicated to Tractor and Garden Pulling
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=147210
Printed Date: 23 Nov 2024 at 11:42pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: ARP head studs for 45

Posted By: Larry(OH)
Subject: ARP head studs for 45
Date Posted: 05 Feb 2018 at 7:03am

can someone help me out with some part numbers for head studs on a 45? I am using a 17 head.

Also, how about an ARP rod bolt for farmall H rods?

Also has anyone used a power bore sleeve? Looking for a part # for that also

Thanks , LH

-------------
'40 WC puller,'50 WD puller,'50 M puller '65 770 Ollie

*ALLIS EXPRESS contact*

I can explain it to you, BUT I cannot understand it for you!!

Replies:

Posted By: wi50
Date Posted: 05 Feb 2018 at 10:00am

I don't have the numbers for the studs, of the few sets I've had to get for people, I just measured and looked on summit racing and picked them out. 1/2"-13 tpi on the bottom and they are 1/2-20 on top. There's a couple different lengths and it's pretty easy to find ones that you would need. The ARP bolts for the Farmall H rods are just 3/8-24 thread bolts, I just picked some from a common Chevy. Again though measure the length, I countersink the bolts in the cap for clearance, I'm pretty sure I still have half a set here (enough for a 4 cyl) if you want them. They use a 12 pt head so you can use a 3/8" 12 pt socket. The sleeves from Power Bore, I use a flange on top, some guys don't and just bore the block so they sit on a step in the bottom counterbore, but that doesn't leave anything to hold the sleeve to the block deck. A flange type sleeve will make the block stronger.

-------------
"see what happens when you have no practical experience doing something...... you end up playing with calculators and looking stupid on the internet"

Posted By: Larry(OH)
Date Posted: 05 Feb 2018 at 8:46pm

How much for the rod bolts? On the H rods did you remove the top of the rod that sticks way out or leave it?

-------------
'40 WC puller,'50 WD puller,'50 M puller '65 770 Ollie

*ALLIS EXPRESS contact*

I can explain it to you, BUT I cannot understand it for you!!