B_clutch questions
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=132468
Printed Date: 24 Aug 2025 at 10:54pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: B_clutch questions
Posted By: Tom Elder
Subject: B_clutch questions
Date Posted: 11 Dec 2016 at 7:39am
Thanks ahead of time,this is a great forum
Question one,what is the difference between a solid clutch and one with springs.
Question 2 is it possible to just replace the 3 release levers ,and where could you obtain new ones.
thanks again Tom
-------------
2 1949bs,one with belly mower one with side sickle bar
|
Replies:
Posted By: PaulB
Date Posted: 11 Dec 2016 at 9:10am
The original factory discs had segmented facings that used a thick one against a thin one and they were alternated on each side. That allowed only half of the facings to make contact at the very beginning of engagement. If your going with all new stuff those are no longer available and you can only get the full circle lining, for which which you'd want a spring loaded center. I have a lot of NOS clutch parts available, some linings and levers.
Do you have an 8-1/2" disc or 9"? There were also a couple different pressure plates used at the factory, that used different parts.
-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY
|
|