HD11 throwout bearing yoke

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

Serial #8878

I found wear on the right steering clutch throwout bearing yoke (part # 620712). The yoke had been tipping in from the top far enough that it ground on the heads of the steering clutch mounting bolts. There were grooves worn in the yoke about halfway up from the bottom. Not a good place for wear..

I found some wear on the ball at the top of the yoke. I replaced the bushings for the trunnion pins. The throwout yoke wear pin at the bottom did not appear to have much wear, but I don't know how thick it was originally. 

Anyway, I don't see any other way to limit the travel of the yoke to prevent it from grinding on the bolt heads.. Any advice?

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Gargoyle Members Profile Send Private Message Find Members Posts Add to Buddy List Silver Level Joined: 29 Aug 2013 Location: Missouri Points: 186	Post Options Post Reply Quote Gargoyle Report Post Thanks(0) Quote Reply Topic: HD11 throwout bearing yoke Posted: 02 Apr 2014 at 10:44am
	Serial #8878 I found wear on the right steering clutch throwout bearing yoke (part # 620712). The yoke had been tipping in from the top far enough that it ground on the heads of the steering clutch mounting bolts. There were grooves worn in the yoke about halfway up from the bottom. Not a good place for wear.. I found some wear on the ball at the top of the yoke. I replaced the bushings for the trunnion pins. The throwout yoke wear pin at the bottom did not appear to have much wear, but I don't know how thick it was originally. Anyway, I don't see any other way to limit the travel of the yoke to prevent it from grinding on the bolt heads.. Any advice?

Sponsored Links