Are pistons & liners matched in a new kit?

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Just received a new overhaul kit from A&I for a CA. Are the pistons and liners matched to each other? They came boxed with the piston inside the liner, but there are no markings or tags that specifically mate the two together? 

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
J&J Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 24 Apr 2021 Location: IN Points: 40	Post Options Post Reply Quote J&J Report Post Thanks(0) Quote Reply Topic: Are pistons & liners matched in a new kit? Posted: 1 hour 17 minutes ago at 12:07pm
	Just received a new overhaul kit from A&I for a CA. Are the pistons and liners matched to each other? They came boxed with the piston inside the liner, but there are no markings or tags that specifically mate the two together?

Sponsored Links

RedHeeler79 Members Profile Send Private Message Find Members Posts Add to Buddy List Silver Level Joined: 09 Sep 2023 Location: NE Kansas Points: 235	Post Options Post Reply Quote RedHeeler79 Report Post Thanks(0) Quote Reply Posted: 51 minutes ago at 12:33pm
	No, they’re generally not matched. Just mass produced and packaged as a set. Would undoubtedly cost considerably more if they were factory matched. As long as the manufacturer maintains tight quality control / tolerances, all should be good. You could take the time to measure piston to wall clearance and ring gap (recommended), and put together the closest matches you can achieve with what you have…. I bet most people don’t though. And if they’re on the loose end of spec, there’s not much you can do anyway.

RedHeeler79 Members Profile Send Private Message Find Members Posts Add to Buddy List Silver Level Joined: 09 Sep 2023 Location: NE Kansas Points: 235	Post Options Post Reply Quote RedHeeler79 Report Post Thanks(0) Quote Reply Posted: 48 minutes ago at 12:36pm
	Unfortunately, most engine parts that i see currently being produced are made overseas (chineseum), and in my opinion, not the top quality that you used to be able to get with the old USA made brands of years ago. I always try hard to find NOS stuff, but not always possible. Sad, but unfortunately what we’re faced with in today’s world. Edited by RedHeeler79 - 47 minutes ago at 12:37pm