This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


49 wd hydraulic pump pressure
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
G226WD View Drop Down
Bronze Level
Bronze Level


Joined: 06 Jul 2011
Location: Canada
Points: 33 		Post Options Post Options   Thanks (0) Thanks(0)   Quote G226WD Quote  Post ReplyReply Direct Link To This Post Topic: 49 wd hydraulic pump pressure
    Posted: 2 hours 14 minutes ago at 3:18pm
Hi everyone say ive got a 49 wd the pump has been in a cardboard box for a few years and I put it back on just recently pump says 1800psi then 1500psi then now its 1000psi i replaced the long small spring the one for high pressure  the old one made the pump chatter when i engage it  id like to know about the shims on the top as well i want to get just under 3000psi if i can  need a little help thanks
Back to Top
Sponsored Links


Back to Top
Allis dave View Drop Down
Orange Level
Orange Level


Joined: 10 May 2012
Location: Northern IN
Points: 3054 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Allis dave Quote  Post ReplyReply Direct Link To This Post Posted: 1 hour 11 minutes ago at 4:21pm
Get a WD or WD45 service manual. It explains the pump very well. I rebuilt mine about 12 years ago.

You need to pull out all 4 of the check valves on top and make sure the springs are good. I think 2 of mine were wore through and I replaced them all and also reseated the balls into the seat. Once that is done and all your orings are replaced. Then you can see where your pressure is at and start adding shims to the unload valve if needed.
Back to Top
G226WD View Drop Down
Bronze Level
Bronze Level


Joined: 06 Jul 2011
Location: Canada
Points: 33 		Post Options Post Options   Thanks (0) Thanks(0)   Quote G226WD Quote  Post ReplyReply Direct Link To This Post Posted: 30 minutes ago at 5:02pm
can i do this while the pump is on the tractor also where in the pump are the orings you are refering to.
i have some parts and pieces for the pump here havent had it mind in pieces in a while part numbers would help  i do not have a service manual    thank you
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.074 seconds.


Help Support the
Unofficial Allis Forum