This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


4th Gear in a 180
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
KevinON View Drop Down
Orange Level
Orange Level


Joined: 07 Dec 2009
Location: Schomberg, ON
Points: 800 		Post Options Post Options   Thanks (0) Thanks(0)   Quote KevinON Quote  Post ReplyReply Direct Link To This Post Topic: 4th Gear in a 180
    Posted: 4 hours 56 minutes ago at 7:21am
Just wondering if anyone could tell me what the tooth count should be on 4th gear (input shaft) on a 180/185?  I have two transmissions, and one gear has 36 teeth and the other gear has 42 teeth.  Thanks.
Back to Top
Sponsored Links


Back to Top
tbran View Drop Down
Orange Level
Orange Level


Joined: 14 Sep 2009
Location: Paris Tn
Points: 3483 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tbran Quote  Post ReplyReply Direct Link To This Post Posted: 1 hour 44 minutes ago at 10:33am
70256571   19 tooth with 15 coupling teeth.   The only one I know of on a 180
70245780 20 tooth 20 coupling - first 190
70245722  19 tooth
70246407 19 with 12 coupling
look on the input gear to see if there is a snap ring groove cut in - if so it is a D series. 


Edited by tbran - 1 hour 38 minutes ago at 10:39am
When told "it's not the money,it's the principle", remember, it's always the money..
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21409 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 46 minutes ago at 11:31am
If you have 36 and 42 teeth on the input shaft to the transmission (direct drive/4th gear) it is custom made. They are usually two parts: a gear (36 or 42) and an input shaft with splines and a snap ring groove to hold on the gear on those splines. A gear that large will not fit thru the input shaft bearing hole in the trans case. A gear that large is assembled from the rear being slid onto the input shaft while the shaft is being installed into the trans case from the front.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum