This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7000 ps end cap
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
tnboss View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 31 Jan 2012
Location: iowa
Points: 11 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tnboss Quote  Post ReplyReply Direct Link To This Post Topic: 7000 ps end cap
    Posted: 14 Dec 2020 at 9:51am
Replacing the low range clutches in my 7000, Has wore grooves in the heavy end plate, can I polish the other side up and flip over afraid grooves will ruin new friction plates. Thanks for any help.
Back to Top
Sponsored Links


Back to Top
NEVER green View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 Feb 2013
Location: MN.
Points: 8679 		Post Options Post Options   Thanks (0) Thanks(0)   Quote NEVER green Quote  Post ReplyReply Direct Link To This Post Posted: 14 Dec 2020 at 10:57am

   Dont see why not, I did on my 7040.
2-8050 1-7080 6080 D-19 modelE & A 7040   R50       
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 22135 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 14 Dec 2020 at 11:59am
I think I would grind the damaged side to smooth. I don't think the front face was ever finished off, was it ??
Back to Top
Hurst View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Midway, Ky
Points: 1218 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hurst Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2020 at 8:02pm
Check for flatness too. Mine was warped when I rebuilt mine. If you’re working on a black belly that uses it as an inching clutch, they take a beating. In all honesty, if I was doing it again and didn’t find a good low hour used clutch pack, I would get a quote from a local machine shop to make one. I don’t remember there being much complicated about them.

Hurst
1979 Allis Chalmers 7000
5800 Hours
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 22135 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2020 at 8:05pm
There may be room enough to make it 1/8" thicker, which would help with warpage over time. Machine it down at the O.D. to still use the same bolts, but thicker where the heat actually is.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.070 seconds.


Help Support the
Unofficial Allis Forum