This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Oil type for trans. & finals on HD6E
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
drtdmn View Drop Down
Bronze Level
Bronze Level


Joined: 03 Nov 2012
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote drtdmn Quote  Post ReplyReply Direct Link To This Post Topic: Oil type for trans. & finals on HD6E
    Posted: 08 Nov 2012 at 3:27pm
Can anyone tell me what type oil is used in the transmission and the final drives of a 1959HD6E? I believe its 90W but i dont know if that is mineral or gear?
Back to Top
Sponsored Links


Back to Top
gemdozer View Drop Down
Orange Level
Orange Level


Joined: 17 Sep 2009
Points: 1066 		Post Options Post Options   Thanks (0) Thanks(0)   Quote gemdozer Quote  Post ReplyReply Direct Link To This Post Posted: 08 Nov 2012 at 4:25pm

You need 80-90w oil gear for transmission and final drive
Back to Top
drtdmn View Drop Down
Bronze Level
Bronze Level


Joined: 03 Nov 2012
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote drtdmn Quote  Post ReplyReply Direct Link To This Post Posted: 08 Nov 2012 at 5:31pm
Thank's and That would be straight 80-90 and not mineral?
Back to Top
Dozer View Drop Down
Orange Level
Orange Level


Joined: 16 Aug 2011
Location: SW New York
Points: 689 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dozer Quote  Post ReplyReply Direct Link To This Post Posted: 09 Nov 2012 at 4:11pm
The operators manual says SAE 50W above 32 degrees and SAE 30W below 32. 90 wt EP oil is a good choise and works well. I am presently using a universal transmission/hydraulic oil because it is less expensive and the HD6's take a lot of oil. In my opinion it is very important to completely drain the old oil because these old machines collect a lot of dirt and condensation. I found a lot of water in my final drive and hydraulic system.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.102 seconds.


Help Support the
Unofficial Allis Forum