| Author |
 Topic Search  Topic Options
|
allis converted 
Bronze Level
Joined: 10 Jun 2011
Location: opolis, KS
Points: 40
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: 190xt pulls intermittently in high range?
Posted: 10 Jun 2011 at 8:09pm |
|
Hello to all I am new to Allis chalmers I have a 190xt when I am working it and try to shift into high range it pulls very slow but it does fine in low range, also when it has no load on it it works fine in high range. I have checked all the fluids could it be a week relief spring in the power director valve?
|
 |
|
Sponsored Links
|
|
|
Leon B MO
Orange Level
Joined: 12 Sep 2009
Location: Old Monroe, Mo
Points: 2191
|
Post Options
Thanks(0)
Quote Reply
Posted: 10 Jun 2011 at 8:20pm |
might check all linkages to make sure it is engaging all the way. I know that was a part of my problem on Dads 200.
Leon B Mo
|
|
Uncle always said "Fill the back of the shovel and the front will take care of itself".
|
|
allis converted
Bronze Level
Joined: 10 Jun 2011
Location: opolis, KS
Points: 40
|
Post Options
Thanks(0)
Quote Reply
Posted: 10 Jun 2011 at 9:21pm |
|
Thanks I will try it tomorrow and let you know if that was it.
|
|
DougG
Orange Level
Joined: 20 Sep 2009
Location: Mo
Points: 8365
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Jun 2011 at 7:18am |
|
Dont run like this too much , you will warp the clutch plates in the POWERDIRECTOR !!! Need to get a 300 lb gauge on a 4 ft section of hyd hose and a FIX IT book to check the pressure going to the high and low side of the POWERDIRECTOR plates , if the pressures to low the plates wont engage fully , slip and break , the pressure is adjust able on the linkage , but also check the linkage attaching points as bushings and pieces wear over time throwing the pressures off ; even loose bolts on the foot deck of the tractor will cause the moving pressures ; oh yeah, you,ll love this tractor !!!
Edited by DougG - 11 Jun 2011 at 7:20am
|
|
allis converted
Bronze Level
Joined: 10 Jun 2011
Location: opolis, KS
Points: 40
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Jun 2011 at 8:42am |
|
I can't find any problems with the linkage I am getting ready to check the pressures. I cant' wait to see what it can do when it is pulling correctly now with only low range working right it has been pulling 6 16" white.
|
|
allis converted
Bronze Level
Joined: 10 Jun 2011
Location: opolis, KS
Points: 40
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Jun 2011 at 11:09am |
|
Does anyone know where I can find the shims for the power director valve, from the pressure readings that seem to be the problem.
|
|
