This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Rod bearing question
 Post Reply Post Reply Page  <1 345
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Hunt4Allis View Drop Down
Orange Level
Orange Level


Joined: 13 Mar 2018
Location: Ohio
Points: 1172 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hunt4Allis Quote  Post ReplyReply Direct Link To This Post Posted: 19 Apr 2022 at 12:10pm
While I'm this far into it I am probably going to check the steering pump out and oil and water pump (any tips for these things?) I plan on just going by the manual and checking things out to make sure they aren't worn out. While I had it running a couple months ago it did seem to have a whining sound in the motor at the front which I'm guessing is the hydraulic pump so I'll probably look at that too...
Thanks Matt

Edited by Hunt4Allis - 19 Apr 2022 at 12:12pm
Back to Top
Sponsored Links


Back to Top
Hunt4Allis View Drop Down
Orange Level
Orange Level


Joined: 13 Mar 2018
Location: Ohio
Points: 1172 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hunt4Allis Quote  Post ReplyReply Direct Link To This Post Posted: 22 Apr 2022 at 5:18pm
Originally posted by SteveM C/IL SteveM C/IL wrote:

I have used strips of old blue jeans or even a multi folded paper towel wrapped and taped around journals. Duct tape lives longer than masking tape.

Am I able to just flush the hole out before I roll the new bearings in with some spray? (Wd40 type spray)?
Back to Top
Hunt4Allis View Drop Down
Orange Level
Orange Level


Joined: 13 Mar 2018
Location: Ohio
Points: 1172 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hunt4Allis Quote  Post ReplyReply Direct Link To This Post Posted: 26 Apr 2022 at 7:55am
In other words I'm asking whether the oil gallery runs horizontal through the crankshaft or is it just a hole that's bored perpendicular to the bearing surfaces? I can't tell by my shop manual...
Back to Top
steve(ill) View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: illinois
Points: 87650 		Post Options Post Options   Thanks (0) Thanks(0)   Quote steve(ill) Quote  Post ReplyReply Direct Link To This Post Posted: 26 Apr 2022 at 8:44am
you should be able to BLOW out the ports with air... if the BEARINGS have not been installed on the mains/ rods .......... there can be DEAD ENDS if a bearing is in place.
Like them all, but love the "B"s.
Back to Top
 Post Reply Post Reply Page  <1 345
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum