This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD/WD45/17 pulling manifold
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Larry(OH) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Shreve Ohio
Points: 1577 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Larry(OH) Quote  Post ReplyReply Direct Link To This Post Topic: WD/WD45/17 pulling manifold
    Posted: 04 Jun 2010 at 3:50pm
Manifold for WD/45/17 engine.  I ran this on my puller when I ran the open RPM classes.  I had it machined off and a new carb flange weled on so it looked stock.  I ran a carb from an "E" gleaner on it (bendix) and it ran great.  It has a 3" center to center on the studs and around 1 5/8" opening in it.  Worked fine, just laying around and looking for a new home.  $125.00
'40 WC puller,'50 WD puller,'50 M puller '65 770 Ollie

*ALLIS EXPRESS contact*

I can explain it to you, BUT I cannot understand it for you!!
Back to Top
Sponsored Links


Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum