| Author |
 Topic Search  Topic Options
|
Russ-neia 
Silver Level
Joined: 11 Sep 2009
Location: NE Iowa
Points: 489
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Hex bushings or tubing source?
Posted: 11 Mar 2010 at 1:20pm |
Looking for some hex tubing or bushings to fit a 7/8" hex hub to a 11/16" hex shaft. Does such a thing exist? I'll only need about 6 or 7 pieces 2" long.
Maybe not in the right category, but I'll be using it on an Allis planter...
|
|
The innovators offer what others will imitate.
|
 |
|
Sponsored Links
|
|
|
orangereborn
Orange Level
Joined: 12 Sep 2009
Location: NW WI
Points: 1450
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Mar 2010 at 1:41pm |
|
Is that the size of the hex setup on the DA 385? Dale
|
|
Russ-neia
Silver Level
Joined: 11 Sep 2009
Location: NE Iowa
Points: 489
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Mar 2010 at 1:44pm |
|
Yes, the line shaft/drill shaft across the back is 11/16". Any of the row-clutches I've found are made for 7/8" hex. I could change out the shaft to 7/8, but then I also have to change bearing hangers and the main drive sprockets.
|
|
The innovators offer what others will imitate.
|
|
john(MI)
Orange Level
Joined: 12 Sep 2009
Location: SE MI
Points: 9262
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Mar 2010 at 2:11pm |
This is where I go, if they don't have it, I go to my friend who is a machinist.
|
|
D14, D17, 5020, 612H, CASE 446
|
|
Rawleigh
Orange Level
Joined: 14 Sep 2009
Location: White Stone, VA
Points: 421
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Mar 2010 at 2:34pm |
|
Get a 6' length of 7/8 hex stock from Mcmaster Carr for $27 and have adapters made with internal keyways. Cut the old shaft into segments and have the ends turned round with keyways. Assemble the shaft in sections on the machine with setscrews holding it together.
Edited by Rawleigh - 11 Mar 2010 at 2:37pm
|
|
Rawleigh
Orange Level
Joined: 14 Sep 2009
Location: White Stone, VA
Points: 421
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Mar 2010 at 2:55pm |
|
Is there any hex PTO telescoping drive shaft out there of the right dimensions? I find plenty of splined couplings and adapters, but not much hex.
|
|
Rawleigh
Orange Level
Joined: 14 Sep 2009
Location: White Stone, VA
Points: 421
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Mar 2010 at 3:20pm |
I don't know how small a lot they will sell: http://www.mstube.com/mech/index.html
|
|
