d14 idle

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I rebuilt the carburetor on my d14 and now it only runs good with the choke half open. What did I do wrong? The idle screw makes no difference.  

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
mhbier Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 17 Feb 2015 Location: Montrose, co Points: 34	Post Options Post Reply Quote mhbier Report Post Thanks(0) Quote Reply Topic: d14 idle Posted: 04 Apr 2024 at 10:58am
	I rebuilt the carburetor on my d14 and now it only runs good with the choke half open. What did I do wrong? The idle screw makes no difference.

Sponsored Links

HoughMade Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 22 Sep 2017 Location: Valparaiso, IN Points: 691	Post Options Post Reply Quote HoughMade Report Post Thanks(0) Quote Reply Posted: 04 Apr 2024 at 11:34am
	Having to leave the choke on is a classic symptom of having a fuel restriction somewhere. Not enough fuel, so to get the ratio right, it has to cut the air. I'd look at the jets first, then go backwards through the fuel passages. Did you replace the jets? If it's not that, less likely, it could have an air leak or the float is way off. If it's a Schebler, the idle screw affects the throttle butterfly so with the choke on, it won't have much effect until the choke is off.
	1951 B

tbran Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 14 Sep 2009 Location: Paris Tn Points: 3298	Post Options Post Reply Quote tbran Report Post Thanks(0) Quote Reply Posted: 04 Apr 2024 at 12:05pm
	The last kit we got to rebuild the MS - the inlet hole the needle goes in was about half the size it should have been - compared to the old seat. We had to drill out the hole. Having said that , as stated you are not getting enough fuel of course - does it idle correctly? That is about the only thing the idle adjustment does. The main load screw - if it has one - the oem carbs did - will flood the engine when screwed out too far and stall it when scewed in. After warmup and the initital setting of 2.5 turns out - turn the screw in til rpm drops then back to where it sounds great - then an extra 1/4 turn out. The main load passage ways/jets and needle seat are the # issue .
	When told "it's not the money,it's the principle", remember, it's always the money..

Ray54 Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 22 Nov 2009 Location: Paso Robles, Ca Points: 4552	Post Options Post Reply Quote Ray54 Report Post Thanks(0) Quote Reply Posted: 04 Apr 2024 at 12:52pm
	It's probably like the others said, but start at the beginning. Is there good flow coming out of the tank?