| Author |
 Topic Search  Topic Options
|
ma2022 
Bronze Level
Joined: 28 Jul 2022
Location: Alberta
Points: 3
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Allis Chalmers 712H bevel gear box
Posted: 01 Aug 2022 at 4:09pm |
Hello,
I'm new to garden tractors and don't know a lot but have been working on my grandparents Allis Chalmers 712H. I replaced the carburetor and the engine starts and runs great. The driveshaft spins but there doesn't appear to be any output from the bevel gear box. The belts don't spin. Am I right in assuming that the beveled gear box needs to be replaced?
|
 |
|
Sponsored Links
|
|
|
HudCo
Orange Level
Joined: 29 Jan 2013
Location: Plymouth Utah
Points: 3542
|
Post Options
Thanks(0)
Quote Reply
Posted: 01 Aug 2022 at 10:43pm |
|
is the coupler on the engine good ?
|
|
Gary
Orange Level Access
Joined: 13 Sep 2009
Location: Peterborough,On
Points: 5391
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Aug 2022 at 7:16am |
|
I believe some of the belt pulleys or bevel gears are keyed to the shaft.
I'd first check for a failed key.
Start by removing the belt and turning the the belt pulley.
G
|
|
Steve in NJ
Orange Level Access
Joined: 12 Sep 2009
Location: Andover, NJ
Points: 11818
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Aug 2022 at 8:49am |
Gary is correct. In lot's of cases, I've found the key in the input shaft of the BGB fails allowing the driveshaft to turn. The problem is sometimes they booger up the imput shaft or does some damage to the keyway where it would lead to pulling the BGB out and getting the keyway/shaft repaired. HTH Steve@B&B
|
|
39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife
|
|
ma2022
Bronze Level
Joined: 28 Jul 2022
Location: Alberta
Points: 3
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Aug 2022 at 11:32pm |
|
Thanks all for the replies. I think the coupler is still good on the engine. That makes a lot of sense about the keys. When I have the chance I will check that. Thanks again for the direction I appreciate it.
|
|
Mikez
Orange Level Access
Joined: 16 Jan 2013
Location: Usa
Points: 8391
|
Post Options
Thanks(0)
Quote Reply
Posted: 03 Aug 2022 at 10:27pm |
With it shut off grab the pulleys sticking out each side and see what they feel like. Spin by hand. You sure those were spinning when engine was running. The left pto side only the outer part of the clutch will spin unless the lever is engaged. But something should be spinning
|
|
