This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Late WD -40 block
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Michael Crowe View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Kansas City
Points: 1722 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Michael Crowe Quote  Post ReplyReply Direct Link To This Post Topic: Late WD -40 block
    Posted: 05 Feb 2013 at 7:36am
How long of a stroke can you fit into this block. I have the block for sale and the potential buyer has asked that question. Thanks michael
The 14th Annual Exclusive AC Swap Meet will be held in Boonville, MO, March 7-8, 2025. See the club website for details: http://www.moacclub.com/
Back to Top
Sponsored Links


Back to Top
wi50 View Drop Down
Orange Level
Orange Level


Joined: 24 Sep 2010
Location: weegieland
Points: 1010 		Post Options Post Options   Thanks (0) Thanks(0)   Quote wi50 Quote  Post ReplyReply Direct Link To This Post Posted: 05 Feb 2013 at 7:54am
It's going to depend on crankpin size and the rod they wish to use. With a smaller 2" crankpin and a well designed billet rod 5.75 would likely fit verry easy with room to spare and no block clearance. 6" would likely not take much work.

It's all going to depend on rod cap angle, rod profile and the size of the crankpin.

With a straight cap rod 5 1/4" might start to get tight. With a canted cap Farmall rod then 5 3/8will fit with verry little work.

I believe block numbers 38 to 40 were a little wider in the crankcase. All the pan rails are the same width but these blocks were wider in the crankcase. I've got one cleaned up in the shop and will throw a 5.4" crank in it later and give you a little better idea.

Edited by wi50 - 05 Feb 2013 at 7:56am
"see what happens when you have no practical experience doing something...... you end up playing with calculators and looking stupid on the internet"
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.082 seconds.


Help Support the
Unofficial Allis Forum