This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7040 water pump volute o-rings
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
DIESEL View Drop Down
Silver Level
Silver Level
Avatar

Joined: 26 Aug 2013
Location: Sandhills
Points: 259 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DIESEL Quote  Post ReplyReply Direct Link To This Post Topic: 7040 water pump volute o-rings
    Posted: 09 Dec 2023 at 8:52pm
In the water pump volute there is only room for 1 o-ring for the water tube to slide into, but the parts book breakdown shows 2. What am I missing fellas. Manual says to put on the tube and slide in but I'd think it would be easier to install in the volute first, any pointers.
Back to Top
Sponsored Links


Back to Top
SteveM C/IL View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Location: Shelbyville IL
Points: 8239 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SteveM C/IL Quote  Post ReplyReply Direct Link To This Post Posted: 09 Dec 2023 at 10:34pm
Kinda remember what yer saying about 2 but it only uses one on each end and they go inside in the groove then the pipe is slipped in. (this is on an 8070 but I think the same) I used a little silicone grease on the oring and tube. Right or wrong.
Went and looked...same for 7040 and 8070.  Both take two 70923621 orings on tube. One per end. Parts books for '40 shows 2 at front of tube in pic and '70 book shows one. Both say in description 2 required. 70923684 is oring between volute and block. You wouldn't guess it from the picture. HTH


Edited by SteveM C/IL - 09 Dec 2023 at 10:49pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum