This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


AC190xt How to set static lift height for mowing
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
whizone View Drop Down
Bronze Level
Bronze Level


Joined: 23 Mar 2018
Location: Texas
Points: 97 		Post Options Post Options   Thanks (0) Thanks(0)   Quote whizone Quote  Post ReplyReply Direct Link To This Post Topic: AC190xt How to set static lift height for mowing
    Posted: 15 hours 19 minutes ago at 8:04pm
All, I have a 65' Allis Chalmers 190xt which I have been doing a lot of mowing/ bush hogging with. My cutter is a 3pt attached mower. Can anyone tell me how to set the lift to a static height? I am wearing myself out raising it to avoid obstacles and then fighting to get it back to the correct cutting height. Your thoughts are appreciated. Thanks much.








Edited by whizone - 15 hours 12 minutes ago at 8:11pm
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20165 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 14 hours 42 minutes ago at 8:41pm
One of the two rear levers on the console is a "Position Control" lever that sets the minimum height for the 3-point hitch arms. Looking at the paint job, I imagine there aren't any decals on those levers. If the position Control linkage isn't froze or broken, it will do exactly what you want and still allow you to raise to go over things and lower right back down to the height you desire.
Back to Top
whizone View Drop Down
Bronze Level
Bronze Level


Joined: 23 Mar 2018
Location: Texas
Points: 97 		Post Options Post Options   Thanks (0) Thanks(0)   Quote whizone Quote  Post ReplyReply Direct Link To This Post Posted: 14 hours 16 minutes ago at 9:07pm
Thanks so much Doc, I was not sure how to get it adjusted. I will see if it is connected and works. 
Back to Top
PaulB View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Rocky Ridge Md
Points: 4652 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PaulB Quote  Post ReplyReply Direct Link To This Post Posted: 4 hours 49 minutes ago at 6:34am
If you had an operators manual and had also read and understood it along with the manuals pictures, you would know how all of your tractor's functions were operated.
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum