This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
F3 won't start |
Post Reply |
Author | |
Ben (MI)
Orange Level Joined: 02 Jun 2010 Location: SW Lower MI Points: 737 |
Post Options
Thanks(0)
Posted: 22 Jun 2024 at 11:58am |
Hello,
I started the combine today so I could move stuff around in the shed. It popped right off like always when it's above 70 degrees out. It ran for 5 seconds and then quit. It will now only fire on either for a second but that's it. I replaced the fuel filter making sure it was full of fuel. I cleaned the sediment bowl which was pretty clean anyway. I noticed that I have a beautiful double stream coming from the tank to the bowl, as long as the bowl is removed from the base. It takes several minutes to fill the bowl when on the base. I tried with the fuel cap off, same deal. There's a half tank of fuel. What is going on here, please? |
|
Part time farming with a 1980 7060 and 1984 F3 hydro.
|
|
Sponsored Links | |
DrAllis
Orange Level Access Joined: 12 Sep 2009 Points: 20528 |
Post Options
Thanks(0)
|
Leave the bail nut loose until the bowl is full and then tighten it up. That is very normal what you are describing.
|
|
Ben (MI)
Orange Level Joined: 02 Jun 2010 Location: SW Lower MI Points: 737 |
Post Options
Thanks(0)
|
Perfect, thank you. Back to the drawing board on the no start. I'm just going through the troubleshooting guide in repair manual step by step. Thanks again!
|
|
Part time farming with a 1980 7060 and 1984 F3 hydro.
|
|
SteveM C/IL
Orange Level Access Joined: 12 Sep 2009 Location: Shelbyville IL Points: 8241 |
Post Options
Thanks(0)
|
My F2 loses it's prime over winter. It will fire right up and then die. Go pump the primer and good to go. Just like my 220.
|
|
Ben (MI)
Orange Level Joined: 02 Jun 2010 Location: SW Lower MI Points: 737 |
Post Options
Thanks(0)
|
Thank you Steve, I will give it a try.
|
|
Part time farming with a 1980 7060 and 1984 F3 hydro.
|
|
analogguy
Bronze Level Joined: 11 Mar 2023 Location: Camp Point Il Points: 6 |
Post Options
Thanks(0)
|
I have seen the fitting on the top of the injection pump plug with pieces of the governor shock ring. Remove fitting and see if it will start.
|
|
Ben (MI)
Orange Level Joined: 02 Jun 2010 Location: SW Lower MI Points: 737 |
Post Options
Thanks(0)
|
Thanks Steve and Analoguy. Priming did the trick, luckily. I didn't want to mess with the pump. Appreciate both of your input. This serves as my reminder to start it monthly in the off season.
|
|
Part time farming with a 1980 7060 and 1984 F3 hydro.
|
|
SteveM C/IL
Orange Level Access Joined: 12 Sep 2009 Location: Shelbyville IL Points: 8241 |
Post Options
Thanks(0)
|
Or just pump the primer before you begin and it will be fine
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |