This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


175 Allis lift cylinder rebuild
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
kenney58 View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 12 Nov 2010
Location: Missouri
Points: 108 		Post Options Post Options   Thanks (0) Thanks(0)   Quote kenney58 Quote  Post ReplyReply Direct Link To This Post Topic: 175 Allis lift cylinder rebuild
    Posted: 17 Jun 2024 at 11:53am
I had read once on replacing cylinder seals on the 3 point lift. Am unable to remove pin in the front of cylinder in front of axle housing. And advice?
Back to Top
Sponsored Links


Back to Top
DSeries4 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Ontario, Canada
Points: 7335 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DSeries4 Quote  Post ReplyReply Direct Link To This Post Posted: 17 Jun 2024 at 3:10pm
Going to need some heat and penetrating oil.  Have done it several times.  Removing the floor pan and traction booster linkage helps a lot.
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
Back to Top
8070nc View Drop Down
Orange Level Access
Orange Level Access


Joined: 21 Mar 2019
Location: North Carolina
Points: 505 		Post Options Post Options   Thanks (0) Thanks(0)   Quote 8070nc Quote  Post ReplyReply Direct Link To This Post Posted: 17 Jun 2024 at 3:18pm
I know D17s4 cylinders and 175 cylinders are probably different but on my D17 i plan to just take the pin out of the rod end screw the cap out pull the rod out and leave the tube on the tractor. Am i think wrong for some reason
1984 80780
1957 D14
DES 300 with 25000 engine
616 tractor
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.125 seconds.


Help Support the
Unofficial Allis Forum