This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7030 transmission fluid transferring
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Orange & silver farm View Drop Down
Bronze Level
Bronze Level


Joined: 29 Jul 2021
Location: Ohio
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Orange & silver farm Quote  Post ReplyReply Direct Link To This Post Topic: 7030 transmission fluid transferring
    Posted: 09 Apr 2024 at 4:39am
7030 is transferring trans oil to rear end. I know this has been discussed before. I pulled filters and screens underneath left and right they were pretty clean. Will get new agco. Figured I need to change the seal to stop the bypassing of oil. Anyone have part number of the seal and is there anything else I'll need? (Gaskets) How big of a job is it to change? Am I going about it right so far? Any suggestions greatly appreciated thanks and first time poster
Back to Top
Sponsored Links


Back to Top
Ron(AB) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2009
Location: Alberta
Points: 958 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron(AB) Quote  Post ReplyReply Direct Link To This Post Posted: 10 Apr 2024 at 10:50pm
Welcome to the forum.

Yes it is probably best to do as many seals as you can when you are in there.
405, 7000, 7050, 8050, 8070, L3, 2300 & 2600 disk
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20567 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 11 Apr 2024 at 3:35pm
70265398 is the seal causing the trouble. Be sure to wrap one layer of electrical tape on the shaft splines to prevent cutting the seal when installing. Other parts needed: two- 70269665 Orings.....one- 70261282 gasket.......one-70924921 oring.  Reuse all the seals you can as many are obselete i am told.
Back to Top
Orange & silver farm View Drop Down
Bronze Level
Bronze Level


Joined: 29 Jul 2021
Location: Ohio
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Orange & silver farm Quote  Post ReplyReply Direct Link To This Post Posted: 11 Apr 2024 at 4:51pm
Thank you that's what I was answer I was looking for. Wanted to get seals before I started repair
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.049 seconds.


Help Support the
Unofficial Allis Forum