This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


HD6G steering drum machinig
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
doctorcorey View Drop Down
Orange Level
Orange Level
Avatar

Joined: 17 Jul 2011
Location: S. KC Missouri
Points: 589 		Post Options Post Options   Thanks (0) Thanks(0)   Quote doctorcorey Quote  Post ReplyReply Direct Link To This Post Topic: HD6G steering drum machinig
    Posted: 29 May 2023 at 9:17am
Well, I dusted off some old adaptors I got when I bought my 60 year old Aamco brake lathe 20 years ago. My steering clutch drums were pretty rusty, and I decided to machine them despite various opinions as to the practicability of doing so. My drums were cupped a bit in the wear area. Expect to eat at least one carbide tip cutting through the very hard and abrasive rust belt, but done carefully, it turned out good. Finish with a super slow cut, and then dress with 150 grit sandpaper by hand. 
Semper Fi USMC    1958 HD6G, 1959 MF 203 loader, 1960 Case 420B Backhoe, MF 65 Tractor/Loader Diesel
Back to Top
Sponsored Links


Back to Top
Codger View Drop Down
Orange Level
Orange Level
Avatar

Joined: 23 Dec 2020
Location: Utopia
Points: 2041 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Codger Quote  Post ReplyReply Direct Link To This Post Posted: 29 May 2023 at 9:19am
Done it in the past myself with no detriment. Dry clutches are kinda bad for it unless used often and then the wear on the surface just like automotive brake drums. 
That's All Folks!
Back to Top
doctorcorey View Drop Down
Orange Level
Orange Level
Avatar

Joined: 17 Jul 2011
Location: S. KC Missouri
Points: 589 		Post Options Post Options   Thanks (0) Thanks(0)   Quote doctorcorey Quote  Post ReplyReply Direct Link To This Post Posted: 03 Jun 2023 at 8:55am
Originally posted by Codger Codger wrote:

Done it in the past myself with no detriment. Dry clutches are kinda bad for it unless used often and then the wear on the surface just like automotive brake drums. 
Been kind of busy with the 6G, replacing my well pump and trying to find seals for my Massey loader. The drum on my left side was pitted up pretty bad and had a layer or mouse 'epoxy' all over it. The right drum didn't get the mice in there and so just has common rust. I'm going after the right side final next....going to attempt to inspect  the intermediate and upper shaft bearings without removing the sprocket. Cheers
Semper Fi USMC    1958 HD6G, 1959 MF 203 loader, 1960 Case 420B Backhoe, MF 65 Tractor/Loader Diesel
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum