| Author |
 Topic Search  Topic Options
|
JC-WI 
Orange Level Access
Joined: 11 Sep 2009
Location: wisconsin
Points: 33886
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Seen this
Posted: 25 Sep 2022 at 11:08am |
Had to laugh at this upgraded tractor. Looks like a good fit.
|
|
He who says there is no evil has already deceived himself
The truth is the truth, sugar coated or not. Trawler II says, "Remember that."
|
 |
|
Sponsored Links
|
|
|
tbran
Orange Level
Joined: 14 Sep 2009
Location: Paris Tn
Points: 3378
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 11:32am |
|
Needed a little pep in its step evidently...
|
|
When told "it's not the money,it's the principle", remember, it's always the money..
|
|
steve(ill)
Orange Level Access
Joined: 11 Sep 2009
Location: illinois
Points: 82810
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 12:47pm |
I can see where that would piss off a million people ! 
wonder what it takes to adapt the bell housing / clutch .
|
|
Like them all, but love the "B"s.
|
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009
Points: 20946
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 5:51pm |
|
Maybe not. Any honest John Deere lover will tell you the 2010 gas engine was probably one of the worst engines ever built by anyone !!! All four wet sleeves were attached to a thick deck plate that sat on top of the block. Known for leaks and head gasket issues and you cannot replace one sleeve...all four is the only way. Truly an idiots design.
Edited by DrAllis - 25 Sep 2022 at 5:52pm
|
|
exSW
Orange Level
Joined: 21 Jul 2017
Location: Pennsylvania
Points: 914
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 6:17pm |
 DrAllis wrote:
Maybe not. Any honest John Deere lover will tell you the 2010 gas engine was probably one of the worst engines ever built by anyone !!! All four wet sleeves were attached to a thick deck plate that sat on top of the block. Known for leaks and head gasket issues and you cannot replace one sleeve...all four is the only way. Truly an idiots design.
|
I hated those little sh!ts. Worked for three different people that had them.
|
|
Learning AC...slowly
|
|
Mikez
Orange Level Access
Joined: 16 Jan 2013
Location: Usa
Points: 8480
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 6:22pm |
|
When you see stuff like this, makes you want to be a fly on the wall of that shop. Beers being drank. What you think was wrong with the poor allis that they robbed the engine from.
|
|
exSW
Orange Level
Joined: 21 Jul 2017
Location: Pennsylvania
Points: 914
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 6:48pm |
Mikez wrote:
When you see stuff like this, makes you want to be a fly on the wall of that shop. Beers being drank. What you think was wrong with the poor allis that they robbed the engine from. |
Calcium ate the rims.
|
|
Learning AC...slowly
|
|
Ray54
Orange Level Access
Joined: 22 Nov 2009
Location: Paso Robles, Ca
Points: 4615
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 7:03pm |
Any one want to try replicating that. I have a nice industrial 2010 with a working back hoe.
I will challenge DrAllis I think JD had one idea even worse, THEY USED THAT DESIGN IN A 6 cylinder. As far as I have found only used in JD 95 combines and cotton pickers of the same time.
A good friend and I ran a 95 hillside with that piece of junk engine and very lucky to get 100 hours out of it without digging into the engine. We ended up using that parts other where pitching using JB weld on the bottom o ring flanges. Seemed to last as good as the guys putting everything new in.
A widow wanted a backhoe out of her yard and called my same friend. He put a battery in and it started. He drove it on his tilt bed and left it sit. He had bigger newer hoe, asked if he should unload it here. After it was here started looking at what I had. Water in the oil. Drained, left plug out pored a a gallon in the radiator in 20 second a gallon of water came out the oil pan. So here it sits for about 5 years now.
|
|
CrestonM
Orange Level
Joined: 08 Sep 2014
Location: Oklahoma
Points: 8410
|
Post Options
Thanks(0)
Quote Reply
Posted: 25 Sep 2022 at 7:31pm |
|
In addition to the engine, what I’ve heard about the 2010s is the whole tractor is bad.Rockshaft problems, hydraulic problems, bad brakes, and poor power assist steering. It seems Dubuque people say Waterloo got all the R&D funding for the 3010-5010, and that’s why the 2010 and 1010 were sub par.
|
|
