This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Classifieds
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


36 m crawler
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
ky crawler View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Sep 2020
Location: fordsville ky
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ky crawler Quote  Post ReplyReply Direct Link To This Post Topic: 36 m crawler
    Posted: 07 Sep 2020 at 9:05pm
Have a 36 m crawler think I have a valve issue it runs little rough have replaced plugs plug wires and had carb rebuilt but I'm afraid to pull head off . i can't seem to find a head gasket listed for a model m crawler.
Back to Top
Sponsored Links


Back to Top
T Hunter View Drop Down
Bronze Level
Bronze Level


Joined: 07 Jul 2019
Location: Kansas
Points: 68 		Post Options Post Options   Thanks (0) Thanks(0)   Quote T Hunter Quote  Post ReplyReply Direct Link To This Post Posted: 07 Sep 2020 at 10:40pm
I have a M as well, it too ran rough after a mag rebuild and carb rebuild.
Got to asking around and found the "tube" for the intake/exhaust manifold from Mr Fouts and by golly it was running smooth as silk again.
Its a preheat chamber in the middle of your manifold. Its to heat up and run low grade fuel or kerosene i belive.....
Just a suggestion.
Back to Top
Dave (Mid-MI) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Hemlock, MI
Points: 544 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dave (Mid-MI) Quote  Post ReplyReply Direct Link To This Post Posted: 09 Sep 2020 at 7:50pm
Didn't the M use the same engine as the UC tractor?
Back to Top
ky crawler View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Sep 2020
Location: fordsville ky
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ky crawler Quote  Post ReplyReply Direct Link To This Post Posted: 09 Sep 2020 at 9:10pm
Yes I was told the u uc and m had the same engine
Back to Top
ky crawler View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Sep 2020
Location: fordsville ky
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ky crawler Quote  Post ReplyReply Direct Link To This Post Posted: 09 Sep 2020 at 9:18pm
Thanks I will look in to that. Did yours suck the exhaust pipe flapper down hard occasionally ?
Back to Top
T Hunter View Drop Down
Bronze Level
Bronze Level


Joined: 07 Jul 2019
Location: Kansas
Points: 68 		Post Options Post Options   Thanks (0) Thanks(0)   Quote T Hunter Quote  Post ReplyReply Direct Link To This Post Posted: 11 Sep 2020 at 9:56pm
My M did not suck the flap down....was very hard to start then ran rough like a miss and surged alot at low speed or no load
Back to Top
ky crawler View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Sep 2020
Location: fordsville ky
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ky crawler Quote  Post ReplyReply Direct Link To This Post Posted: 12 Sep 2020 at 6:21pm
Mine starts fairly easy and it will run smooth then it will start sucking the flap down then it will run smooth again . I have another problem now I took the top of transmission off to replace a broken steering lever spring and now I don't have any left steering I must have knocked the steering clutch fork out of place when putting the transmission top back on.
Back to Top
Pete from IL View Drop Down
Silver Level
Silver Level


Joined: 29 Dec 2009
Location: Beecher IL.
Points: 311 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Pete from IL Quote  Post ReplyReply Direct Link To This Post Posted: 21 Sep 2020 at 7:57pm
Are you wanting to sell your crawler or just asking questions?
Back to Top
ky crawler View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Sep 2020
Location: fordsville ky
Points: 12 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ky crawler Quote  Post ReplyReply Direct Link To This Post Posted: 23 Sep 2020 at 10:18pm
No it is not for sale . I am just trying to acquire information on parts and learning how to work on it . Everything on it is pretty well wore out so I have a long way to go.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum