| Author |
 Topic Search  Topic Options
|
Steve A 
Silver Level
Joined: 12 Apr 2012
Location: NLP Mi
Points: 245
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: WD wide front/Narrow steering parts
Posted: 22 Sep 2017 at 2:45pm |
|
Could anybody advise me if the steering mechanism (worm, bearings, major interior parts) are the same on a narrow front WD and a 4 bolt wide front WD45? I have a wide front that keeps getting locked up and difficult to turn and a spare narrow front end from a WD. Would like to keep the 45 a wide front and thinking of swapping some parts but hate to tear into it and find out I was making a bad assumption.
Thanks
|
 |
|
Sponsored Links
|
|
|
CAL(KS)
Orange Level
Joined: 18 Sep 2009
Location: Chapman, KS
Points: 3804
|
Post Options
Thanks(0)
Quote Reply
Posted: 22 Sep 2017 at 3:18pm |
I just checked the agcopartsbooks and the worm gear is same # but the sector gear on the vertical shaft is different # for each
if you want to look into it further
Edited by CAL(KS) - 22 Sep 2017 at 3:22pm
|
|
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15
|
|
Steve A
Silver Level
Joined: 12 Apr 2012
Location: NLP Mi
Points: 245
|
Post Options
Thanks(1)
Quote Reply
Posted: 22 Sep 2017 at 3:55pm |
|
Thank you.
|
|
Sugarmaker
Orange Level
Joined: 12 Jul 2013
Location: Albion PA
Points: 8484
|
Post Options
Thanks(0)
Quote Reply
Posted: 22 Sep 2017 at 6:27pm |
|
Call Sandy Lake and talk to there tech guy. As said, a few parts may be interchangeable???
But this sounds like it needs to be taken care of anyway so might as well take the wide front apart enough to see what the problem is. I assume you have checked the steering "U" joint?
Maybe jack it up a little and see what the issue is?
Pictures are always good.
Regards,
Chris
|
|
D17 1958 (NFE), WD45 1954 (NFE), WD 1952 (NFE), WD 1950 (WFE), Allis F-40 forklift, Allis CA, Allis D14, Ford Jubilee, Many IH Cub Cadets, 32 Ford Dump, 65 Comet.
|
|
MACK
Orange Level
Joined: 17 Nov 2009
Points: 7664
|
Post Options
Thanks(0)
Quote Reply
Posted: 22 Sep 2017 at 10:00pm |
|
Make sure a pin in ujoint is not coming out catching oil pan or block. MACK
|
|
