This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Multi purpose bucket |
Post Reply |
Author | |
doctorcorey
Orange Level Joined: 17 Jul 2011 Location: S. KC Missouri Points: 570 |
Post Options
Thanks(0)
Posted: 16 Jul 2012 at 5:39pm |
There were armadillos in the area.......
|
|
Sponsored Links | |
CTuckerNWIL
Orange Level Joined: 11 Sep 2009 Location: NW Illinois Points: 22810 |
Post Options
Thanks(0)
|
Hope the bucket cylinders don't leak down
|
|
http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
|
DMiller
Orange Level Access Joined: 14 Sep 2009 Location: Hermann, Mo Points: 29597 |
Post Options
Thanks(0)
|
Still pretty cute, you get your control valve from the old boy in Illinois to stop the bucket creep Corey?
|
|
doctorcorey
Orange Level Joined: 17 Jul 2011 Location: S. KC Missouri Points: 570 |
Post Options
Thanks(0)
|
No new control valve yet. I'm going to pull down the lift rams and repack them. I'm waiting for my new tranny pump to arrive so I can straighten out my pressures first. Then I'll finish my restoration. The machine works just fine, but I like everything to be in the "green".
|
|
DMiller
Orange Level Access Joined: 14 Sep 2009 Location: Hermann, Mo Points: 29597 |
Post Options
Thanks(0)
|
I have been having the big issues on mine, finally got the strainers(both) out of the trans and cleared them, the bottom one was a hairball, the main feed supply strainer was absolutely a chia pet with so much crap attached to it, you may want to open them up while you work on it. I had to make my own gaskets but they are not that hard to do, NAPA sheet stock paper gasket. The main feeder was slowing my steering way down, to the point it would just quit, today I ran it for an hour and a half before the two steering filters finally loaded up, should be close to the bottom on bottoms rubbish. Had a problem getting the steering pump to prime itself yesterday, figured the pump was shot but pulled the inlet hose today, a little ATF down the throat and it pulled suction and started working again.
My Hydraulics also bleed down, just par for the course on a old machine I think.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |