This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
190 Rams |
Post Reply |
Author | |
Charlie175
Orange Level Joined: 11 Sep 2009 Location: Shenandoah, VA Points: 6351 |
Post Options
Thanks(0)
Posted: 26 Apr 2017 at 7:32am |
The RAMS on my 190xt (I think they are the 3" ones) are leaking.
How hard is it to replace the seals/wiper/o-ring in these? |
|
Charlie
'48 B, '51 CA, '56 WD45 '61 D17, '63 D12, '65 D10 , '68 One-Ninety XTD |
|
Sponsored Links | |
MACK
Orange Level Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
|
Take them off, unscrew outer nut, then pull shaft and packing out. Use cylinder hone to polish the best you can. Unscrew bottom nut and remove old packing. Loosen outer nut to replace oring. Lotite outer nut, screwing it against oring. Put new packing on lower nut, using Lottie on threads and stew nuts tight togather. Use a lot of grease on packing to put back into barrel. Tighten outer nut and put back on. MACK
|
|
Charlie175
Orange Level Joined: 11 Sep 2009 Location: Shenandoah, VA Points: 6351 |
Post Options
Thanks(0)
|
Thanks Mack!
|
|
Charlie
'48 B, '51 CA, '56 WD45 '61 D17, '63 D12, '65 D10 , '68 One-Ninety XTD |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |