HD6E steering problems

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   what is the problem , slips, or wont release ? 
if they slip they need cleaning , depending if updated to HD11 or they have the old fiber clutch plates. 
 Look inside clutch/brake housing (accessable through plate on rear casting top) clean out all the crud inside case. Next install a 3/4" plug in lower side of case in drain hole . Add 3 to 4 gallons cleaning agent into each clutch housing (diesel or stoddard solvent) run machine back and forth and work clutches and brake to get solvent into clutch drum.
 Remove cleaner from case , block clutch levers in pulled position, to allow to dry. leave set for while to get all solution to drain from unit. Work machine lightly to finish drying unit.
 If brake bands are worn or not adjusted the machine will not turn sharply so might need to adjust bands and the support bolt on bottom of case that holds ban from ridding on drum .
HD5 and HD6 use the same rear housing and parts in the final drives, HD11 Clutch plates and discs are the same size but a different drum and count of plates.

Edited by Coke-in-MN - 19 Apr 2011 at 12:37pm

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Coke-in-MN Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Location: Afton MN Points: 41226	Post Options Post Reply Quote Coke-in-MN Report Post Thanks(0) Quote Reply Posted: 19 Apr 2011 at 12:35pm
	what is the problem , slips, or wont release ? if they slip they need cleaning , depending if updated to HD11 or they have the old fiber clutch plates. Look inside clutch/brake housing (accessable through plate on rear casting top) clean out all the crud inside case. Next install a 3/4" plug in lower side of case in drain hole . Add 3 to 4 gallons cleaning agent into each clutch housing (diesel or stoddard solvent) run machine back and forth and work clutches and brake to get solvent into clutch drum. Remove cleaner from case , block clutch levers in pulled position, to allow to dry. leave set for while to get all solution to drain from unit. Work machine lightly to finish drying unit. If brake bands are worn or not adjusted the machine will not turn sharply so might need to adjust bands and the support bolt on bottom of case that holds ban from ridding on drum . HD5 and HD6 use the same rear housing and parts in the final drives, HD11 Clutch plates and discs are the same size but a different drum and count of plates. Edited by Coke-in-MN - 19 Apr 2011 at 12:37pm
	Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something. "Challenges are what make life interesting; overcoming them is what makes life meaningful."

Sponsored Links

oljoe Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 19 Apr 2011 Location: Missouri Points: 37	Post Options Post Reply Quote oljoe Report Post Thanks(0) Quote Reply Posted: 19 Apr 2011 at 12:02pm
	My brother and I just bought a HD6E. The engine and master clutch work fine but the steering clutches and brakes work for maybe 2 turns and quit working. Can someone tell me where to start looking to fix the problem.